Description
CAN BUS Training Board
Technical specifications and functions
- The training board is equipped with a CAN gateway 2.0 network system that includes:
– Dashboard ;
– Engine ECU;
– Smart Key, ignition module, lock module;
– SRS Airbag ECU ;
– Central CAN Gateway module (ECU)
– Front and rear doors control modules;
– Front and rear windows lifting motors
– Front and rear windows lifting switches
- All the components are connected to the internal network. The Network is shown as a diagram for better understanding;
- The modules communications can be connected or disconnected by banana plug jumpers. There can be disconnected Low and High speed CAN lines on the stand;
- CAN getaway diagram with built in banana plug jumpers for measurements and simulation of system malfunctions;
- Ability to simulate more than 10 system faults;
- The window lifting motors are active and controlled by a switches and doors control modules through CAN gateway network of the car;
Diagnostic and measurement
Oscilloscope/multimeter
- System’s parameters are measured by connecting to the banana connector
- Ability to measure electrical signal parameters of system component
Control unit diagnosis
- Diagnosis through OBD 16 – pin diagnostic connector
- Diagnose all presented control units in the CAN bus network by using an automatic search (depending on the diagnostic tool possibilities)
- Diagnose of each control module separately
- Electronic control unit (ECU) identification
- Reading/erasing fault codes
- Displaying the operating system parameters (live data)
- Activating the actuators (Depends on the control unit)
- Control unit encoding/configuration (Depends on the control unit)
